Willem programmer software version 0.97g or latest.
Verified chips on mentioned adapter are underlined. Details find in chip_test.xls file
Software may not support some chip, report problem in Willem/EZoFlash forums.

GROUP A (Uniform sectors)

Selected device group Flash 29/39/49Fxxx > M29F0x0 TSOP40 >…
- Vcc=5V. Jumpers Jp1,Jp3 (5.0V), Jp5 (A18)
AMD AM29F080, AM29F080B, AM29F016, AM29F016B, AM29F016D, AM29F032B, Atmel AT49F080, AT49F080T Fujitsu (MBM) 29F080, 29F080A Hynix HY29F080, Macronix MX29F080, MX29F016 SGS/ST Micro M29F080A, M29F080D, M29F016B, M29F016D
- Vcc=3.3V. Jumpers Jp2 (3.6V), Jp5 (A18)
Atmel AT49LV080, AT49LV080T, AT49BV080, AT49BV080T

Create solder bridge between flash chip pins 1 and 2 (adapter psop44b3, no documents available).
Following chips are supported:

GROUP E (Vpp, Symmetrical Block)
Selected device group Flash 28Fxxx > 28F00x 8bit > …
- Vcc=5V, RST=Vpp=12V. Jumpers Jp1, Jp3 (5V), Jp5 (A18)
Intel (PA, TB) 28F008SA, PA28F004S5, PA28F008S5, PA28F016S5 Sharp LH28F008SAN,
LH28F008SC(H)N-V
- Vcc=3.3V, RST=Vpp=12V. Jumpers Jp2 (3.6V), Jp5 (A18)
Intel (PA, TB) 28F004S3, 28F008S3, 28F016S3 SGS/ST Micro M28V841, M28V161
- Smart voltage Vcc=3.3/5.0V, RST=Vpp=12V
Jumpers Jp2 (3.6V), Jp5 (A18) or
Jumpers Jp1, Jp3 (5V), Jp5 (A18)
Intel (PA, TB) 28F004SC, TE28F008SC, TE28F016SC Sharp LH28F002SC(H)N, LH28F004SC(H)N-L, LH28F008SC(H)N-L, LH28F016SC(H)N-L