Willem programmer software version 0.97g or latest.
Verified chips on mentioned adapter are underlined. Details find in chip_test.xls file
Software may not support some chip, report problem in Willem/EZoFlash forums.

- Smart voltage Vcc=3.3/5V. Vpp=12V.
Jumpers Jp1, Jp3 (+5V), Jp5 (A18), Jp8 (12V), Jp9 (sel.Vcc=5V) or
Jumpers Jp2 (Vcc=3.6V), Jp5 (A18), Jp8 (Vpp=12V)
Intel E28F016SA Sharp LH28F016SANS
- Smart voltage Vcc=3.3/5V. Vpp=5/12V.
Jumpers Jp1, Jp3 (+5V), Jp5 (A18), Jp7 (Vpp=5V), Jp9 (sel.Vcc=5V) or
Jumpers Jp1, Jp3 (+5V), Jp5 (A18), Jp8 (Vpp=12V), Jp9 (sel.Vcc=5V) or
Jumpers Jp2 (+3.6V), Jp5 (A18), Jp8 (Vpp=12V)
Intel E28F016SV
- Vcc=5V. Vpp=5V. Jumpers Jp1, Jp3 (+5V), Jp5 (A18), Jp7 (Vpp=5V)
Intel DT28F160S5, DT28F320S5 Sharp LH28F160S5(H)NS, LH28F320S5(H)NS
- Vcc=2.7-3.6V. Vpp=3.3V. Jumpers Jp2 (+3.6V), Jp5 (A18), Jp7 (Vpp=3.6V)
Intel DT28F160S3, DT28F320S3 Sharp LH28F160S3(H)NS, LH28F320S3(H)NS
- Vcc=5V. Vpen=5V. Jumpers Jp1, Jp3 (+5V), Jp5 (A18), Jp7 (5V)
Intel (DA, DT) 28F320J5, 28F640J5

16Mb chips can be programmed on Willem SW 0.97g or latest version, selected device i28F016, i28F160-T, i28F160-B,LH28F160-T or LH28F160-B.

Highest density (32Mb-64Mb) chips are not supported in existing SW versions.
Chips can be programmed in 16Mb parts, selected device LH28F160-T/-B.
Jumpers Jp10 (A21), Jp9 (A22) allow manage highest adress manually. Set jumper to get low level (log0) adress, remove jumper for high level (log1) adress.
Source file split in 16Mb parts. Load 16Mb block, erase, blank check, write, verify on each block:
0-16Mb Jp10 on (A21-low), Jp9 on (A22-low) ; here check valid get ID response.
16-32Mb Jp10 off (A21-high), Jp9 on (A22-low)
32-48Mb Jp10 on (A21-low), Jp9 off (A22-high)
48-64Mb Jp10 off (A21-high), Jp9 off (A22-high)