EZoFlash форум

Hello EZO, I´ve wired the adapter the same as yours for ezoflash. I get correct chip ID Intel 0x17, can select different blocks with jumper 10 and 09 and erase blocks. Software is 0.97ja, pcb is set in 3.0 Mode, device is LH28F160-B. Blank check is good on all blocks. My problem, I can´t write block...

Thank you for your answer this was very helpfull

I will test it and will come back tommorow with results.

Hello, I´am in need to program a Intel Strata 28f640J3 TSOP-56. I have a TSOP48(8/16BIT) Base Adapter and a Willem PCB 4.5. I´ve wired a TSOP-Multiadaper to the Base Adapter but only get the manufacture ID which is Intel. The baseadapterconnection is labeled on the board. I´ve pinged out the address...

Hi Ezo, I´ve edited my picture. I replaced BC557 with a new BC557 . I had only one 327 so i replaced the 327 above and the two BC547. Then I replaced all cd4015bcn with HCF4015BE, still no vpp. I wanted to buy the other ics also but they were out of stock, but I will order today so I can replace the...

Unfortunately I´ve shortened my willem sivava pcb4.5 programmer. I haven´t looked close enough and set 2 jumpers wrong. I´ve set the Jumpers (the green ones) as shown in the pic below. The gold one weren´t set. The dip setting was for an am29f032. I entered Test H/W and measured vpp until it drops t...