EZoFlash форум

Ezo писал(а):I do not have experience on serial chips. M95080 was verified OK*(first byte read error), you can read from my chip test file. Another 8KB chip Microchip 25LC080 fail due to different page size.

OK. No problem.
Thanks dear Ezo for your help.
I really appreciate it.

Dear Ezo, The problem is fixed now. I tested another two chips and found out that my chips were corrupted. So I got two new M95080 and M95160. I programmed M95160 successfully. Even it reads the chip without any problem. The first two bytes are ok too. I should perform the read command twice. The fi...

But when I try to write another file onto the chip, it fails with the following error: Error at 0x000000 Chip=0xff buffer=0x46 Read chip, what is in buffer, comparing to source ? Dear Ezo, I tried to read the chip after I write it with error. The first time that I read it, it returns a buffer fille...

Dear Ezo,
Do you have any idea ?

Best Wishes.

Dear EZO, I made the modification to the existing working EzoFlash+ 4v4. I connected the M95080 to the programmer using the 25xxx connection model as you have described in the modification schema which is as follows: Chip pin 1: WE Chip pin 2: D Out Chip pin 4: GND Chip pin 5: D In Chip pin 6: D1 Ch...

Ezo писал(а):Programmer will keep functionality on other adapters/chips with 0.97ja
Report if my utilities fail, because changes in serial part makes my programmer Willem compatible.

Thanks again.
Sure I'll put the test result here.
Best Wishes.

Dear EZO,
Thanks for your reply.
So, do you mean that I can still program other not serial chips too without any problem ? I mean chips that are not serial like PLCC32 and etc.

Thanks in advance.

Best Regards.

Dear EZO, If I make this changes on my working board (EzoFlash+ v4.4), then is it able to program the chips that it used to program ? Or it is only able to program SPI chips then ? I want to program these two chips: M95080 and M95160. Will it be able to program these two or not after making new chan...

Dear EZO, If I make this changes on my working board (EzoFlash+ v4.4), then is it able to program the chips that it used to program ? Or it is only able to program SPI chips then ? I want to program these two chips: M95080 and M95160. Will it be able to program these two or not after making new chan...