EZoFlash форум

It turns out I have been barking up the wrong tree this entire time. The laptop I was using to connect to the Willem programmer was not compatable and I had assumed it was a programmer hardware error. The problem with to voltages at pins 22 and 26 were a non issue as the 27c010 only needs a minimum ...

I am trying to program an EPROM (27C010) and all instructions that I find say I need to set the jumper settings to 6.2v to program an EPROM chip. I have deduced that removing J8 from my board (Kee Electronics "2010 PCB50") should set the voltage to 6.2, but the board now fails the software "Test Har...