EZoFlash форум

Hi everyone
can the EzoFlash do H27UAG8T2MTR by Hynix if not anyone now which programmer will

thanks

Hi, Ezo and Members , just want to give a feedback about my findings ...I ordered 5 new Spansion s29GL128N from eBay and when i got them yesterday i soldered a chip on the TSOP48D3 adapter . the chip's came already programmed with some data as the seller said that the Vendor had them mass programmed...

Thanks Ezo for all your efforts and Time , i Really appreciate taking the time to confirm everything . My conclusion is either something wrong with my TSOP48D3 adapter ( because the PCB din't come out in a quality that i trust and had to repair some traces) Or the S29GL128N has come kind of protecti...

Thanks Ezo , i will wait for your testing results ,

Hi, i Guess i'm up a dead end , i just would like to ask did anyone succeeded in Erasing and Writing the S29GL128 and have the same setup as mine ( Willem PCB3, EzoWill, and TSOp-48D3 or is it an experimental thing !. The answer will be a turning point for me to either construct a new TSOP48D3 adapt...

Yes , Please check my reply above i answered all these .

Hi, EZO .. i re-soldered the 2K2 resistor back to the adapter and now i'm back at Square 0 , the data still exist in the chip and i cant erase it ,
do you think by having the WP# pin connected to VCC without the 2K2 resistor did damage the CHIP ?

OK.... I found something interesting , on the TSOP48D3 Page the adapter Photo shows 5x2K2 installed but on the Component view it shows only 4x2K2 resistors and the one is missing is the one attached to the WP# Pin. when i assembled my TSOP48D3 adapter i followed the component view diagram and didn't...

Check read result (first 32MB) in buffer after adress 0x00FFFF. In case of protected first sector expect content up to 0x00FFFF, then should be erased FF FF Normal Data after 0x00FFFF NOT FF FF What chip type do you have - full name with type at the end (-R1..-01 ,...)? S29GL128N 11TFI 01 (i used 2...

Hi, EZO , Yes the Chip is Recognized Correctly and giving the same ID as in your 29GL128 programming instruction . the Buffer Read Locks OK check the Hex image.(have to do 32 byte swab to view the file correctly) i did apply the extID_erase16.zip utility to erase but it always finch the 300sec and s...

Hi, thanks for the help EZO , my VCC 4.98V and VPP 12.71v, i did find some issues with the TSOP ZIF Socket it was deformed by Heat and some pins where not making contact , so i removed it and soldered the ship directly to the PCB , Now it reads the right ID and it says AMD 0x0001 and Dev 0x227E , i ...

Hi, my first Post , can someone please help or give hints why this chip will not Erase, i can read all 4 parts , but it will not let me erase (using ERASE2 or extID_erase16) . My hardware : Willem pcb 3.0b (Dip switches and VPP jumper as the software shows.) EZOWILL cross adapter , (followed the ins...