Willem Programmer 5.0 Atmega162?
I have a WP 5.0 with latest software 097D12C3 and when I select Atamega162 it says use 6pin ISP adapter. How to program this chip? Where can I get this adapter? How to connect? Where to connect? Please help!!!
Re: Willem Programmer 5.0 Atmega162?
Atmega and ATtiny are supported with latest SW 0.98d12c3.
Chips/adapter are connected to Willem programmer SPI 25xxx socket. Extra oscillator based on 4069 required on adapter .
Schematic is available for ezoflash here, file avr.pdf
AVR pins RTS to be connected 25xx/1 (S4/CS), MISO to 25xx/2 (SO), GND to 25xx/4 , MOSI to 25xx/5 (SI), SCK to 25xx/6 (SCK), Vcc/AVcc to 25xx/8 (Vcc), XTAL1 to oscillator
Chips/adapter are connected to Willem programmer SPI 25xxx socket. Extra oscillator based on 4069 required on adapter .
Schematic is available for ezoflash here, file avr.pdf
AVR pins RTS to be connected 25xx/1 (S4/CS), MISO to 25xx/2 (SO), GND to 25xx/4 , MOSI to 25xx/5 (SI), SCK to 25xx/6 (SCK), Vcc/AVcc to 25xx/8 (Vcc), XTAL1 to oscillator
Re: Willem Programmer 5.0 Atmega162?
emeren ,
try making a simple cable with 2 ic sockets .
cheap and if done carefully will last long time.
see attached pictures , my soldering works........... , NOT all my schematics
techy
try making a simple cable with 2 ic sockets .
cheap and if done carefully will last long time.
see attached pictures , my soldering works........... , NOT all my schematics
- original schematic provided by another forum member
- ISP 6 pin.jpg (25.71КБ)8227 просмотров
- my addition to make that cable compatible with my other programmer
- isp 10 pin.jpg (58.47КБ)8227 просмотров
- the set i prepared for my usual programming needs
- m_IMG_0666.jpg (169.92КБ)8227 просмотров
techy