Страница 1 из 1
Spansion S29AL008D
Добавлено: Ср июн 12, 2013 5:40 pm
vx1
Hello,
I've Willem Eprom PCB5.0 (V50a) with T01 + T07 from Sivava.
The program version is 0.98D12c3.
Selected S29AL008D and I get the ID: Manufacturer: 0x01 AMD; Device code: 0x5B Am29LV800B
Erase and Read OK.
But it program only at 49%.
Any advice is welcome!
TIA
Re: Spansion S29AL008D
Добавлено: Ср июн 12, 2013 7:38 pm
Ezo
Apply adress cable between adapter and programmer
Re: Spansion S29AL008D
Добавлено: Ср июн 12, 2013 8:13 pm
vx1
The cable is ok and in the right position.
Re: Spansion S29AL008D
Добавлено: Ср июн 12, 2013 9:14 pm
Ezo
What is error message ?
Adress ? Is value from chip in message same like from file first adress (from beginning) ?
Re: Spansion S29AL008D
Добавлено: Ср июн 12, 2013 10:08 pm
vx1
No error message, just stops. The progress bar stops at 49%, freezes.
Comparing the data in 49% (0 to 7FFFF), everything is ok.
Re: Spansion S29AL008D
Добавлено: Чт июн 13, 2013 7:23 pm
Ezo
Try with selected device Requested Adapter 3.3V, 29LVx00 8/16bit, 29LV800
What position of jumper left from dipswitch panel ?
Re: Spansion S29AL008D
Добавлено: Ср июн 19, 2013 1:15 pm
vx1
Ezo, thank you for your help!
I managed to burn the chip with your tip to use Requested Adapter 3.3V, 29LVx00 8/16bit, 29LV800 and adapters T08 + T01!
Thank you very much!