EZoFlash форум

in my tests I read the chip 29C010D general, I used the configuration of AT29C010A (JUMPER 1,3,5), only read the chip, the recorder is OK with other chips

I read the chip 29C010D

What full chip name, manufacturer ? What is Get ID reply ?
Erase and write chip with SW 0.97g.
Erase fail on small sector chips (AT29C010, SST29EE010,...) with 0.97ja. You can overwrite chip without erase.

the software they use is the SW 0.97g, the chip is generic ( TAIWAN ), the chip does not contain a description of the manufacturer, only the model 29C010D, I can not overwrite, delete, write, read only, the ID does not return any , the D of 29C010 (D) is the type socket of chip ( DIP )

tanks for response

the ID does not return any

ID return always, man. and chip names explanation can be omitted.
ID is correct, if response is different from 0xFF and different from chip content in first 2 adress (check with read).
Try activate SW option Disable Software data protect.
Try with selected chip SST PH 29EE010 in SW.

with AT29C010 selected returns 0x2F [...] - 0x2F, with SST PH29EE010 returns 0xDF [...] - 0xDF , trying to overwrite ( error - Write sector 0 ) , in test H/W , only the pin 11 - A10-23 the voltage this 4.60 volts on / 0.00 volts off, the rest is the voltage this 4.78 volts on / 0.00 volts off

http://www.ezoflash.com/chip_database.p ... ter=dip32a- would this chip?

No, this is different chip. No data available.
Mentioned voltage differencies are not critical.
Strange different ID return. What is chip content in first 2 adress from read/buffer ?
Possible chip is not supported.

following the image buffer to read the chip, the chip is the bios of a motherboard

Possible chip is not supported.

I also believe this because the recorder this ok