Страница 1 из 1
mx29lv800cttc
Добавлено: Пт сен 27, 2013 2:38 pm
phantomEVO
how i have to set willem software to program this eeprom?
Re: mx29lv800cttc
Добавлено: Пт сен 27, 2013 6:45 pm
phantomEVO
please help me!!
Re: mx29lv800cttc
Добавлено: Сб сен 28, 2013 11:42 am
phantomEVO
help help help!
Re: mx29lv800cttc
Добавлено: Вс сен 29, 2013 11:27 am
phantomEVO
please help me! could you tell me if i can switch this eeprom with another eeprom because i don't understand how to flash it
Re: mx29lv800cttc
Добавлено: Вс сен 29, 2013 8:21 pm
phantomEVO
ezo where are you please help me
Re: mx29lv800cttc
Добавлено: Ср окт 02, 2013 7:52 pm
Ezo
Chip is programable with your pcb5.0 and tsop adapter as provide in parallel topic picture .
Check programmer in Test H/W mode. Check all jumpers. Note chip is 3.3V device , remove only one jumper Open 3.6 - programmer or adapter. Apply SW according jumpers jumpers- pcb50 and SW 0.98d12c3
Get valid ID reply !!!!