EZoFlash4v5 preview

[Ezo]

That's good news and strange. I was unable to get success on Atmel SPI Flash AT25DF/AT26DFxxx
(see chip test file)

[tps_star]

second chip test :
MX25L1605 (SELECT DEVICE IN SOFTWARE = MX25L1605)
ERASE OK
READ OK
PROGRAM OK
VERIFY OK

[Ezo]

second chip test :

HW should work. For me is important to have info on problems, missing info, suggestions.
Please mail me your programmer picture, share pcb making process, .....

[tps_star]

hi ezo
problem in my pcb and i found short pin connected
when i disconnect short pin programmer work

[tps_star]

my pcb ezo4.5

[Ezo]

Good preview, modidifications start before public launch !

[tps_star]

hi ezo
check your email

[Lex-]

Hi ezo and tps_star,

excellent work on new PCB 4v5 but I'm little disappointed... some months ago I constructed my own EzoFlash+ 4v4 with lot of effort, specially making holes, then I wait months for the new design to see if finally be SMD... nope ...

I prefer a more "friendly" design (SMD), is more easy obtain SMD chips than make 100 holes on the PCB (a lot of time, patience and broken bits)

Ezo please consider build a special 4v5 SMD version if possible, I will really appreciate your effort !

tps_star you consider make more modifications to the 4v5 design (full SMD) ?

Let me know.

Thanks.

[Salah]

Hi tps star
can you programm Atmel Spi with an 4.5 willem interface mod for 3.3 volt

i't can't give id
read buffer good
but erase ok blank ok but still have the old buffer

i try at26df041



and good new programmer ezo
what about USB?

[tps_star]

hi ezo
i test again at26df161 but program ok and verify not ok and stop in 50% or 60%
but at26df161a program and verify ok
please check at26df161a

[tps_star]

hi ezo
check pcb or not yet?