EZoFlash форум

hi ezo please upload schematic and pcb fbga64_a1

ezo please upload pcb and schematic

schematic not created , pcb and component layout
http://www.ezoflash.com/adapters/fbga64a1/fbga64a1.zip
5 jumpers allow manage adress A24-A25-A21-A22-A23 manually.

hy Ezo possible to share me the adapter pcb schematic of fbga adapter ? i will make without any problem

Hy Ezo possible to share me the adapter fbga64 a1 pcb schematic.

Thank you very much.

hello .
I need ezo -up48 adapter schematic and up48 pcb schematic , possible to share?
thx
in this arhiv only pcb print layout fiind ...

This adapter work for this?

hy EZO possible to upload schematic and ic list and how to use with 5 jumper .. pls

I have to find my draft docs. Adapter was created on my friend request and no final docs prepared. Here is schematic, components and layout of tsop48d3 (except jumper block) in one side of fbga64a1 adapter. In other adapter side pull-up resistors for RST and WP, 5 pull-up resistors with jumpers to ground highest adress.

hello , pls i need the schemaitic ..
pls upload it .
thx

original here

not this i need ...
i need EZO -UP adapter schematic .. and one documentaion how i can set jumpers for read and write the chip 28f128 .

Hi all here's a little info bga64 pin from the pin-out is complete.
http://www.sendspace.com/file/u0zhba

hi ezo

is it possible to describe how to use bga64 adapter?
I created pcb from your shared diagrams, I have adapter ebga64, but there are 5 pins to change adresses and there is my pronlem, how to use it.

BR

Zbyszek

Hi

can some one help me with this ??

BR