Spansion S29AL008D

[vx1]

Hello,

I've Willem Eprom PCB5.0 (V50a) with T01 + T07 from Sivava.
The program version is 0.98D12c3.
Selected S29AL008D and I get the ID: Manufacturer: 0x01 AMD; Device code: 0x5B Am29LV800B
Erase and Read OK.
But it program only at 49%.
Any advice is welcome!

TIA

[Ezo]

Apply adress cable between adapter and programmer

[vx1]

The cable is ok and in the right position.

[Ezo]

What is error message ?
Adress ? Is value from chip in message same like from file first adress (from beginning) ?

[vx1]

No error message, just stops. The progress bar stops at 49%, freezes.
Comparing the data in 49% (0 to 7FFFF), everything is ok.

[Ezo]

Try with selected device Requested Adapter 3.3V, 29LVx00 8/16bit, 29LV800
What position of jumper left from dipswitch panel ?

[vx1]

Ezo, thank you for your help!
I managed to burn the chip with your tip to use Requested Adapter 3.3V, 29LVx00 8/16bit, 29LV800 and adapters T08 + T01!
Thank you very much!