Willem 4.0 Programmer Schematic

[Amrad]

Does anyone know where I can get the schematic for the Willem 4.0 programmer? Thanks.

Regards,

Dave.

[Ezo]

Here are different versions of Willem 4.0 Mark your version from gallery

[Amrad]

Hello Ezo,

Thanks for your reply. Unfortunately, I didn't find the schematic for the version 4.0 that I have. Is there anywhere else where I might find the schematic? Thanks.

Regards,

Dave.

Here are different versions of Willem 4.0 Mark your version from gallery

[Ezo]

What is your programmer ? Picture, link ?
http://www.ezoflash.com/willem/gallery.html

[Amrad]

Hello Ezo,

Thanks for your reply. My programmer is this one:



Regards,

Dave.

What is your programmer ? Picture, link ?
http://www.ezoflash.com/willem/gallery.html

[Amrad]

Anybody know?

[Ezo]

http://www.ezoflash.com/willem/board40.zip
http://www.ezoflash.com/willem/w40.gif
http://www.ezoflash.com/willem/How_to_u ... rammer.pdf

[Amrad]

Hello Ezo,

I've taken a look at the 'How to...' file and find that in the lists of supported ICs, for the MCS-48,MCS-41 series of microcontrollers, it gives this:

D8748,D8749,D8742,D8741, D8742 Vea = 18V

I cant find any explanation as to what is 'Vea', I'd appreciate it if you could let me know. Thanks.

The schematic is rather difficult to read, because there are many overlapping component values and reference numbers, etc.!

Regards,

Dave.

http://www.ezoflash.com/willem/board40.zip
http://www.ezoflash.com/willem/w40.gif
http://www.ezoflash.com/willem/How_to_u ... rammer.pdf

[Ezo]

in the lists of supported ICs, for the MCS-48,MCS-41 series of microcontrollers,

MCS-48 adapter required. No experience here.

I cant find any explanation as to what is 'Vea',

I suppose it is Vpp. Not sure 18V required

The schematic is rather difficult to read

That is Willem original programmer doc's. Better than nothing.

...Willem 4.0 programmer

it's old hardware version. Apply 0.97ja or 0.97jc13 for parallel (ZIF/PLCC/adapters) memory.
Read/search willem 4.0 related topics in old willem forum here

[Amrad]

Hello Ezo,

Thanks for your reply.

in the lists of supported ICs, for the MCS-48,MCS-41 series of microcontrollers,

MCS-48 adapter required.

I do have that adapter.

No experience here.

OK.

I cant find any explanation as to what is 'Vea',

I suppose it is Vpp.

I suppose it might be, but it would be nice to know for certain.

Not sure 18V required

I wondered about that, too.

The schematic is rather difficult to read

That is Willem original programmer doc's. Better than nothing.

Indeed it is, but it does make things difficult.

...Willem 4.0 programmer

it's old hardware version. Apply 0.97ja or 0.97jc13 for parallel (ZIF/PLCC/adapters) memory.

I have 0.97ja but I don' recall seeing 0.97jc13.

Read/search willem 4.0 related topics in old willem forum here

I have been reading posts on the old Willem forum. Haven't seen anything relative so far.

Regards,

Dave.