EZoFlash4v5 preview

[Ezo]

New programmer EZoFlash+ 4v5.
- pcb45 / 0.98 compatible hardware
- added serial support
Doc's package and more info wait later.

[F4nT4sm4]

hi ezo, beautifull board, supports the former adaptadpres?

[Ezo]

Yes, all former adapters are compatible with new programmer.
New adapters for serial chips (SPI, I2C, Microwire EEPROM, SPI Flash, PIC)

[tps_star]

hi ezo
is beautifull
is possible give schematic
and this programmer can working with software 0.98D10 ?

[Ezo]

Hardware Willem 0.97/0.98 compatible.
Do you have interess to create ezoflash4v5 from my documents and come back with test results ?

[tps_star]

yes
i will make and test

[tps_star]

hi ezo
i donot receive your email
please send to this email
amiriran123@gmail.com

[tps_star]

hi ezo
thancks for schematic
i will soon make and test
please give me schematic ser_a1 adapter
thancks

[Ezo]

look in topic

[tps_star]

hi ezo
i make ezo4.5 but cannot working
when i connect to lpt port and run software and click test hardware
error message hardware error
and your schematic R19 = 2k2
but in component picture R19 = 10k
how is right ?
thancks

[Ezo]

Correct R19 value 2k2.
Go Test H/W and first check 32-Vcc (Vcc, Vcc2, LED, IC8/14, voltage on pull-up resistors at IC8 logic outputs)
Click/unclick on D0 (OE on) and measure voltage changes on IC8 logic inputs/outputs.
This reply was mailed to you yesterday.

[tps_star]

hi ezo
i check and all ok
but vcc2 in normal mode have 0.9 volt and when click vcc(test hardware) vcc2 volt is 4.30 volt
this volt is normal ?

[tps_star]

hi ezo
i found problem
thancks for help

[MaXiM4747]

Hi all

Can you tell us what was the problem?

thank you!

[tps_star]

hi
nothing
problem in my pcb and i found short pin connected
first chip test :
AT26DF161 (SELECT DEVICE IN SOFTWARE = AT25DF161)
ERASE OK
READ OK
PROGRAM OK
VERIFY OK