new usb flash programmer

[tps_star]

this picture for new usb flash programmer

usb flash programmer.jpg (196.23КБ)53172 просмотра

[dryupitz]

Very interesting. This is a free project? Is there a schematic and source firmware?

[Gregory]

This is a free project?

Хорошо бы.

[tps_star]

hi
schematic usb flash programmer

[dryupitz]

Hi!

Ok! Good! Thank's, tps_star

Firmware and software for PC available?

[tps_star]

yes available
when make pcb i give you

[dryupitz]

Ok.
What chips support this programmer?

[tps_star]

this programmer nor flash memory tsop48 same as MX29LV160BT or S29AL016D and you can add new device

[Ezo]

this picture for new usb flash programmer

tps_star
Why do you copy/paste information without references ? Provided info not your proprietary, no improvements. Have you created sample and results with SW ?
My comments:
- This is design by misyachniy, web link available here .
- Design created by author only on one customer demand early in 2008
- Author is having good experience in ARM controllers, but not intended to develop programmer.
Take all as it is. We have a lot of USB programmer schematic ideas , drivers and software developing still problematic.

[tps_star]

this programmer support low device
i working to this programmer for change hardware for support many device
or if not possible i design new hardware and software with my freind
you will not help me for design new usb programmer
i tell you i ready for new project ezoflash6 usb but you before start project closed project and delete topic ezoflah6
you working old hardware lpt port
new labtop and pc have not this port and lpt port is out
why you stop ezoflash6 ?
why you like lpt port ?
you just change your hardware with low change for work new software willem
if willem not design this programmer you can make new programmer ?
i am your freind but you think i am your enemy or rival
make programmer is my hobby
i like make new hardware with support many device without change any jumper or dip switch or many adapter for device

[Ezo]

why you stop ezoflash6

I am working alone here out of forum , programmers are hobby out my daily business and family . If here is no interesents and real workers in software part, I stop.
Note, I am ready for hardware support on different chips - AT90USB1287/Atmega128+FT232RL (ezoflash6), PIC18F4550 , AT91SAM7S256, ready for tests and HW/SW improvements
Start from beginning with USB drivers, chips software and programmer soft - not ready.

[tps_star]

you design hardware i help you for software
pic18f4550 and at9asam7s256 is good and at91sam7s256 is better
you can design hardware with at91sam7s256 and one cpld or fpga ?
if you ready for hardware i help you for software (driver and programmer software )
so you design hardware and give me your schematic and document i start software for you hardware

[Ezo]

My interess is keep EZoBus and existing adapters.
CPLD implementation can be extended or next version of software

[tps_star]

ok
start with support your existing adapters

[tps_star]

how time you start ?